Glossary term
Transformer Testing
The measurements and tests made on a power or distribution transformer at the maker's works, and sometimes on site, to show it meets the standard and the figures guaranteed in the contract.
Last reviewed by the OdysseyGPT team
What it is
Transformer testing is the set of measurements and tests made on a transformer at the maker's works to show it meets the standard and the guaranteed figures in the contract. IEC 60076-1 sorts the tests into routine tests on every unit, type tests on a representative unit and special tests the purchaser asks for.
Key Takeaways
- Routine tests are made on every transformer. Type tests are made on one unit of a design.
- Special tests are made only when the purchaser asks for them and it is agreed.
- The contract can add tests, ask for witnessing and set the report format.
- The records are routine test reports, type test reports and calibration certificates.
Why it matters
Transformer testing is the set of measurements and tests a manufacturer makes on a finished transformer before it leaves the works. The purpose is twofold: to find manufacturing faults, and to show that the unit meets the standard named in the contract and the figures the maker guaranteed. Under IEC 60076-1 the tests fall into three categories. Routine tests are made on every transformer. They include measurement of winding resistance, voltage ratio and a check of phase displacement, short-circuit impedance and load loss, and no-load loss and current, together with dielectric tests. Type tests are made on one unit that represents a design. The temperature rise test is the usual example. Special tests are made only when the purchaser asks for them, such as a short-circuit withstand test or a frequency response measurement. The standard also covers operation tests on an on-load tap-changer and leak and pressure tests on the tank of a liquid-immersed unit. Buyers who work to IEEE use C57.12.00 with the test code C57.12.90, and the categories and names differ. A contract can add to any of these lists, ask for tests to be witnessed and set how results are reported. The records that come out are a routine test report for each serial number, type test reports and the calibration certificates of the instruments used. Read the edition of the standard your contract names for the tests that apply to your transformer.
How OdysseyGPT uses it
Document Review checks the test clauses of a tender against your test procedure, inspection and test plan and list of type test reports, and quotes both sides for each finding. Calibration Validity Check (beta) matches the instruments named in a test report to their calibration certificates. OdysseyGPT reads documents only. It does not test a transformer, it is not test-bay software, and engineers decide every result.
Evaluation questions
What does a tender usually say about transformer testing?
It names the standard, lists any tests the buyer adds to the routine list, says which type and special tests are wanted and whether existing reports are accepted, and sets witness rights, notice periods and the records to be supplied.
Frequently asked questions
What are the routine tests on a transformer?
Tests made on every unit. Under IEC 60076-1 they include winding resistance, voltage ratio and phase displacement, short-circuit impedance and load loss, no-load loss and current, and dielectric tests. The full list depends on the transformer and on the edition, and the contract may add to it.
Is a transformer factory acceptance test the same as routine testing?
They overlap. Routine tests are defined by the standard and made on every unit. A factory acceptance test is the contract event at which the buyer or its inspector witnesses some or all of the tests the contract lists, which can include type or special tests.
Who witnesses transformer tests?
Whoever the contract names: the purchaser, its engineer or a third-party inspector. The inspection and test plan marks which tests are witness or hold points and the notice the maker must give.
References
IEC 60076-1:2011 Power transformers. Part 1: General
IEC
Paid standard. Catalogue page and free preview used for scope and clause headings.
IEEE Transformers Committee
IEEE Power & Energy Society
Maintains IEEE C57.12.00 and the test code C57.12.90.
